Installation Instructions

JEEP Wrangler TJ

Fender Emblem Overlay Decal Installation Instructions

CLEAN/PREP SURFACE
• For best results the air temperature needs to be at least 50°F or 10°C
• Clean the raised emblem area with soapy water or your favorite cleaner
• Make sure the surface is free of remnants and residue from OEM decals
• DRY the area. The decals are DRY INSTALLATION ONLY

PEEL
• Remove the WHITE PAPER backing from the decals EASY!!

POSITION
• Position the new decals over the existing raised “JEEP” imprint

STICK
• LIGHTLY tack the decals to the fender using the top corners of the tape
• Make sure positioning is correct
• Gently smooth FROM THE CENTER up, down, left and right to affix the decals
• DO NOT REMOVE TOP LAYER OF APPLICATION TAPE

PRESS
• FIRMLY smooth the entire decal. The adhesive is PRESSURE SENSITIVE so PRESS DOWN
• Remove application tape starting in the top corners and pulling down slowly
• If a letter does not release from the application tape, reposition the tape with letter and FIRMLY press the letter onto the surface of the Jeep and repeat the tape removal
• Any bubbles are easily removed through “Air Channels” built into the vinyl
• Use tool or finger to work any air bubbles to the edge of the decal

ADMIRE
• Stand back and admire your work!"